Phatbox / Keg software and support > Phatnoise Hardware Support

Pinouts

(1/2) > >>

sbingner:
http://www.bingner.com/phatnoise - email me your pinouts/post them here and I'll keep updating the site

I would really like the sony pinouts, I can get an adaptor for my car to convert to sony protocol...

Sam

skew:
does anyone have a toyota pinout?? I would like to play around with it.

jonah:
I just posted a link to my Audi Pinouts here:

http://forum.phathack.com/cgi-bin/yabb/YaBB.cgi?board=dmshack;action=display;num=1111457660

staydin:
I'm trying to make a harness for my audi from the attached diagram.

I'm not really sure what is meant by the pins that go to a 'shield?'

If someone could explain what it means and what I'm supposed to do with it, I would greatly appreciate it.

Thanks

http://audi.805net.com/phatbox/audi_phatbox_pinout.gif

sbingner:
That means the wire is connected to the outside of the connector, or the 'shield' --- that is usually used for ground

Navigation

[0] Message Index

[#] Next page