PhatHack
Phatbox / Keg software and support => Phatnoise Hardware Support => Topic started by: sbingner on March 17, 2005, 09:45:46 pm
-
http://www.bingner.com/phatnoise - email me your pinouts/post them here and I'll keep updating the site
I would really like the sony pinouts, I can get an adaptor for my car to convert to sony protocol...
Sam
-
does anyone have a toyota pinout?? I would like to play around with it.
-
I just posted a link to my Audi Pinouts here:
http://forum.phathack.com/cgi-bin/yabb/YaBB.cgi?board=dmshack;action=display;num=1111457660
-
I'm trying to make a harness for my audi from the attached diagram.
I'm not really sure what is meant by the pins that go to a 'shield?'
If someone could explain what it means and what I'm supposed to do with it, I would greatly appreciate it.
Thanks
http://audi.805net.com/phatbox/audi_phatbox_pinout.gif
-
That means the wire is connected to the outside of the connector, or the 'shield' --- that is usually used for ground
-
Well the outter "ring" if the connector as well as a metal foil around the single cables (underneath the outter rubber/plastic) serves as a shield against signal noise transmitted by other electronic parts. It just improves sound soundquality and is connected to ground.
Para