PhatHack

Phatbox / Keg software and support => Phatnoise Hardware Support => Topic started by: vs2 on July 28, 2005, 07:24:36 am

Title: BMW to Audi
Post by: vs2 on July 28, 2005, 07:24:36 am

Hi. I'm new here.
I'm trying to use my Phatbox from my BMW(sold) into my 2003 Audi RS6. I got the correct cable from Clairparts.com and installed the correct firmware for Audi (7.02) onto the DMS.

Absolutely nothing happens though, no lights etc. I've tried the procedures over and over.

I'm sure I read on the Phatbox forums that this could be done or do I need a special Phatbox to work with an Audi. The other thing it could be is that the harness installed between the HU & CD changer is not correct. (was installed by Audi)

Any help would be appreciated.

BTW, well done for starting up this site.

Title: Re: BMW to Audi
Post by: az1324 on July 28, 2005, 08:03:07 am

NO lights?  Ever?  Well that means the phatbox isn't even getting power so the harness is not installed correctly.  Otherwise, you might need to read this: http://www.phatnoise.com/downloads/3301-HUSETUP_web.pdf

Title: Re: BMW to Audi
Post by: vs2 on July 28, 2005, 08:23:32 am

Thanks, but that .pdf shows what to do after the PB is up and running.

I'll go to Audi tomorrow and borrow a CD changer and hook it up to make sure the harness is installed properly.

I've got a funny feeling that a BMW, Acura etc
PB won't work with Audi.

Title: Re: BMW to Audi
Post by: sbingner on July 28, 2005, 09:07:30 am

There are certain types, Terry Kennedy had posted what was compatible with what on the old forums... but I can't find it right now

Title: Re: BMW to Audi
Post by: vs2 on July 28, 2005, 07:56:24 pm

It would be good to find out. If they are not compatible then why would Phatnoise make the cable ends the same (interchangeable)?

Title: Re: BMW to Audi
Post by: vs2 on July 29, 2005, 03:01:26 am

OK fixed. For some reason I did not think these units needed to be grounded. As I have attached the PB to the storage door (plastic) it needed a ground to work.

Thanks anyway.

Title: Re: BMW to Audi
Post by: sbingner on July 29, 2005, 07:11:47 am

Quote

OK fixed. For some reason I did not think these units needed to be grounded. As I have attached the PB to the storage door (plastic) it needed a ground to work.

Thanks anyway.

Strange, there should have been a ground wire in the cable connecting to the head unit....