If you have a 1.2 rev phatbox and are willing to open it up and take some macro shots then please PM me or post here.
Thanks.
also, please post photos of the cable used to connect to the head unit...
Actually whoever posted the pics of the 910 keg could you check where pin 18 on the 26 pin connector goes? It looks from the pics like it might go directly to pin 4 on the winbond but its hard to tell.
I don't have my DMM handy to beep test it but its either pin 4 or pin 6.. 99% sure its pin 4 though. Just happen to have one of my kegs apart on my desk still.. hehe.
reposted below for clarity..
I was putting pin 1 at the top right since pin 1 on the cable diagrams was top left.
So pin 3 as numbered in the datasheet right?
Is that a direct connection or are there intermediate components?
I said that backward.. assuming pin 1 is on the right side of the phatbox side of the connector
13-----------1
26-----------14
Ok actually I was thinking of this numbering:
13 ------------- 1
26 ------------- 14
and here is the pin numbering i was using:
(http://aycu18.webshots.com/image/5057/2004199415368637815_rs.jpg)
It connects to T1. P3.5, pin 17 on my 8052
I need to have my morning pick me up before I post again prior to heading to work. I screwed up my connector numbering when I put it in again. lol your numbers are correct, I have since corrected my post. thanks for waking me up
So just to clarify ... pin 18 on the 26 pin connector goes to pin 17? or pin 4? or both? im confused. :-/
forget pin 4.. im brain damaged, again.
The cut corner, which goes to the right side of the board toward the RCA outputs means that the connection goes to the last pin on the side closest to the external connector.. or pin 17.