« previous next »
Pages: [1]   Go Down

Author Topic: Pinouts  (Read 7634 times)

0 Members and 1 Guest are viewing this topic.

Offline sbingner

  • Administrator
  • Veteran.
  • *****
  • Posts: 1301
Pinouts
« on: March 17, 2005, 09:45:46 pm »
http://www.bingner.com/phatnoise - email me your pinouts/post them here and I'll keep updating the site

I would really like the sony pinouts, I can get an adaptor for my car to convert to sony protocol...

Sam
« Last Edit: March 17, 2005, 09:46:11 pm by sbingner »
Logged

Offline skew

  • A few posts under my belt.
  • *
  • Posts: 31
Re: Pinouts
« Reply #1 on: March 18, 2005, 02:18:11 am »
does anyone have a toyota pinout?? I would like to play around with it.
Logged

Offline jonah

  • Newbie
  • Posts: 3
Re: Pinouts
« Reply #2 on: March 22, 2005, 02:27:35 am »
Logged
(2001 Audi S4/RedPB/80gb)

My Audi Install: http://forums.audiworld.com/s4/msgs/1255425.phtml.

Offline staydin

  • Newbie
  • Posts: 2
Re: Pinouts
« Reply #3 on: April 20, 2005, 08:39:35 pm »
I'm trying to make a harness for my audi from the attached diagram.

I'm not really sure what is meant by the pins that go to a 'shield?'

If someone could explain what it means and what I'm supposed to do with it, I would greatly appreciate it.

Thanks

http://audi.805net.com/phatbox/audi_phatbox_pinout.gif
Logged

Offline sbingner

  • Administrator
  • Veteran.
  • *****
  • Posts: 1301
Re: Pinouts
« Reply #4 on: April 21, 2005, 07:27:15 pm »
That means the wire is connected to the outside of the connector, or the 'shield' --- that is usually used for ground
Logged

Offline para

  • Senior Member
  • Veteran.
  • *****
  • Posts: 181
Re: Pinouts
« Reply #5 on: April 22, 2005, 03:14:47 pm »
Well the outter "ring" if the connector as well as a metal foil around the single cables (underneath the outter rubber/plastic) serves as a shield against signal noise transmitted by other electronic parts. It just improves sound soundquality and is connected to ground.

Para
Logged
Pages: [1]   Go Up
« previous next »