Author Topic: DMS pinout  (Read 5379 times)

0 Members and 1 Guest are viewing this topic.

Offline LinXP

  • Newbie
  • Posts: 3
DMS pinout
« on: November 14, 2009, 01:55:10 am »
Hi All!
Please, i need full pinouts or skhema for this connector.


Tnx

Offline LinXP

  • Newbie
  • Posts: 3
Re: DMS pinout
« Reply #1 on: November 17, 2009, 06:58:37 pm »
I want to connect directly to HDD

please help me

Offline Terry_Kennedy

  • Moderator
  • Veteran.
  • *****
  • Posts: 253
  • There and back again
Re: DMS pinout
« Reply #2 on: November 17, 2009, 09:56:24 pm »
I want to connect directly to HDD

please help me

The easiest thing to do is to remove the drive from the DMS, which will give you a generic 2.5" mini IDE connector. If you can wait a couple weeks, I'll be posting the schematic for my redesigned cradle circuit board and you can get the pinout from that.

Offline LinXP

  • Newbie
  • Posts: 3
Re: DMS pinout
« Reply #3 on: February 08, 2010, 10:08:25 pm »
I'm waiting already 4 months  :'(

Offline S80_UK

  • Global Moderator
  • Veteran.
  • *****
  • Posts: 392
  • Volvo S80 D5 with VW Phatbox
    • Volvo Phatbox Installation
Re: DMS pinout
« Reply #4 on: February 08, 2010, 10:59:59 pm »
Four months and you did not chase before now...? :o

(actually it is still less than three months, but my point is the same)

Anyway - should we assume you do not have a DMS?  So the photo was not of your DMS, it came from someone else?

The real question is this...  Has your Phatbox already had the hack applied?  If it has not, then even with the pin-out information, you will not be able to make it work with another drive.   The hack can only be applied using an original DMS.  

If your Phatbox has already been hacked then it will work with a non-original DMS.   Please confirm the current status of your Phatbox.  I will be able to post the connection details, but it will take a little time. (not three or four months, though)
« Last Edit: February 08, 2010, 11:02:32 pm by S80_UK »